Gather all the materials listed to get started on this project.

Take your nylon cord and fold it in half with a loop on one side and two end cords on the other. Insert the cord into the ring and pull the looped side up and over the ring. Pull the end cords through and tug it to form a lark’s head knot around the base of the ring.

Now grab another jump ring and pull the ends through it. Attach the lobster claw clasp to the ring.

Measure the width of your wrist and place the second jump ring at the other end of the required length. Keep in mind that the length of the bracelet should extend to include the two jump rings.

Secure the clasp to your work surface with some tape. Make a set of square knots starting at the base of the jump ring.

Next, insert the beads and charms on either side of the cords and work your way through to the other end.

Repeat another set of just square knots right up to the top of the second jump ring.

Snip off the extra ends and use a lighter to melt the nylon cord to avoid fraying and to secure it in place.

Your macrame bracelet is ready to wear!