To make this bracelet, start by making a loop with the left tail shorter. You will be working your way through using the right tail.

Bring the right part over and then behind the loop.

Pull the right tail through the loop to create a smaller loop. Tug the shoelace to tighten the knot.

Repeat this process of pulling the shoelace above, behind, and then through the loop.

Continue until you have reached the end of the lace or the desired length. These steps are repetitive, so all you need to do is to make sure that the loops you make every time are secure in their knots.

However, they should not be fastened too tight, or the bracelet could curl under the pull.

Pull the final loop through and tug it into a knot to complete your bracelet. You can either leave it as it is and just tie it in place when you wear it, or you can close the loop.

To finish the closed-loop of the bracelet, you need to bring both tails together and over each other.

Wrap the right tail around the left a couple of times, firmly yet not too tight. Pull the right tail through and under the loops you’ve wrapped and secure it firmly in place.