Gather all the different supplies that have been listed out to get started on this project.

First, roll up one sock into a ball, and then stuff it into the other sock. Push the balled sock right to the end.

Next, grab your toilet paper roll and push it into the sock. You will need to push the roll in till the very end, where the balled sock sits.

Next, tuck the ends of the sock into the roll. Smooth out any wrinkles, if needed.

Grab a compass and measure half the height of the toilet roll(or less, if you want smaller wings).

Then, on a sheet of red paper, draw a circle without altering the radius—which will be half the height of the toilet roll.

Use a black marker to draw over the pencil outline of the circle.

Draw a line down the center and divide the circle into two equal hemispheres.

Proceed to draw round circles in either hemisphere and then fill them up.

Don’t forget to draw antennae, as well.

Now, grab a pair of scissors and cut out the different components. This is when you cut the circle into two hemispheres. So, you’ll have those two hemispheres and a pair of antenna cut-outs.

Adhere the top of one wing to the toilet roll and hold it in place till it sticks. Repeat this step with the other wing.

Next, adhere a couple of googly eyes and then, finally, the two antennae.

You can also consider sticking a clothespin to the bottom of the roll. This will help you clip the ladybug onto different surfaces if required.