Collect all your materials.

Cut the wire so that the length of it is long enough to loop around your finger and the bead. I used six inches.

Put the marker in the middle of the wire’s length, then wrap the ends up and over once.

Twist both tails in an anti-clockwise motion, creating a little “gap”.

Thread a bead onto one of the wire’s tails, nestling it at the base of your loop.

Take the same end of the wire and wrap it around the bead. Make sure to start from the top of the bead and wind down. Keep the circles tight and close together.

Make sure to leave a bit of wire sticking out to prevent any injuries from trying too hard to bend the wire. Instead, use the pliers to wrap the final piece around the ring.

Repeat the same procedure with the other side of the wire.

Just like that, you’ve got a gorgeous ring that’s perfect for you! Try out the dual-sided variation above for something a little different.